TM 1-4940-355-12&P
SHOP EQUIPMENT CONTACT MAINTENANCE (SECM)
BACK DOOR COMPONENT
INITIAL SETUP
Personnel Required:
Tools and Special Tools:
One MOS 67 Series or MOS 68 Series
Tool Kit Acft. Maint, B01 (Table 2, WP 0025 00)
References:
Materials/Parts:
TM 1-1500-204-23-10
100 Grit Paper, (Item 6, WP 0031 00)
Repair Parts and Special Tools List (WP 0027 00)
Acetone, (Item 1, WP 0031 00)
TM 43-0139
Permabond Cyanoacrylate (Superglue) Adhesive, (Item
2, WP 0031 00)
Equipment Conditions:
MIL-P-23377, Primer (Item 8, WP 0031 00)
SECM Assembled (WP 0020 00)
MIL-C-22750, Number 34094 (Green 383) (Item 9, WP
Number 8802 extrudable sealant (Item 4, WP 0031 00)
DISASSEMBLY
NOTE
Only disassemble as far as necessary to get to the part to be replaced.
NOTE
The following steps should be performed for each door.
1. Remove 3 rivets (1) and hasp (2) or 4 rivets (1) and staple (2). (Figure 1 on next page)
2. Remove 20 rivets (3), hinge (4) and door (5 or 6).
3. Remove 11 rivets (7) and door stop (8) from left door (5).
4. Remove door seal (9 or 10).
5. Loosen 2 locking bolts (11).
6. Turn D-ring lock handle (12), causing rods (13) to become disengaged from blocks (14).
7. Turn 2 rods (13) 1/4 turn and remove from D-ring lock (12).
8. Remove 4 rivets (15) and D-ring lock (12) with handle.
9. Remove 8 rivets (16) and 2 blocks (14).
0016 00-1
