TM 10-5411-236-13&P
0005 00
YOKES
FORK POCKET
ADAPTER INSTALLED
BAIL BAR END
PLS CURBSIDE
INSTALL/REMOVE
1.
Select the proper forklift adapter plug to be installed, depending on the side being installed. An
improper plug will not align properly.
2.
Position yoke to saddle under container cross-members at proper fork pocket opening.
3.
Slide fork pocket adapter plug into fork pocket opening until yoke retainer holes align with mating
holes in cross-members.
4.
Insert the two -inch connector pins and secure with spring wire retainers.
5.
Repeat steps 1 through 4 for the roadside.
SECURING ASLMS TO PLS TRAILER
CAUTION
Caution must be exercised when transporting the ASLMS on the M1076 PLS trailer on
cross-country terrain that can produce excessive vibration and shock. When conditions
simulate the 6-inch washboard effect, damage may result to the ASLMS container and
the material stored within, when driving at excessive speed for this condition. Operators
should always adjust driving speed to local conditions for safe operation. If a 6-inch
washboard effect is encountered, it may be necessary to reduce speed to as low as 3
miles per hour to avoid damaging the ASLMS and its contents.
1.
After loading the ASLMS on to the M1076 PLS trailer, pinning holes must align with mating holes in
M1076 PLS trailer frame. If these do not align, recheck orientation of rear roller assembly and fork
pocket adapter plugs. Ensure rollers on rear roller assemblies contact the roller stops on the M1076
PLS trailer. Correct as necessary.
0005 00-19
Change 1
