TM 10-5411-236-13&P
0005 00
5.
Place jaws into corner block openings.
6.
Tighten jaws using the 2 1/8-inch structural wrench by turning the adjuster nut as tight as possible
towards the installer.
7.
Turn jam nut towards the closest jaw and tighten counterclockwise firmly.
8.
Repeat procedure for opposite side of containers.
9.
Return to the ground via the roof access system on the end of the FPU-8.
INSTALLING/REMOVING REAR ROLLER ASSEMBLY
Detachable dual 7-inch rollers are mounted under the rear end of the FPU-8 container and attached to
the underside of the lower end rail with two -inch attaching pins and secured by four linchpins. When
attached to the FPU-8 and combined with the FPU-12, the rear rollers enable the container to be loaded
on the HEMTT-LHS, and M1076 PLS trailer. The rear rollers are off center in the roller frame so the roller
extends past the rear of the FPU-8 frame when installed. When detached and stored within the FPU-12
section, they permit the container to be stacked or transported via standard ISO container transportation
methods and devices.
Change 1
0005 00-16
