TM 5-3610-256-14
i. Install autotransformer and secure with screws and Iockwashers.
j. Reconnect wiring. Refer to the Wiring Schematic, FO-2. Connect wires 29, 30, 33, and
34 to terminal 1.
k. Reinstall rear cover. Secure door of receptacle assembly with screw.
l. Plug in power cord.
m. Power ON.
n. Perform functional test.
5-12. REPLACE IDLER ROLLERS DRIVE ROLLER, AND PRINTER BELTS.
TOOLS: Flat-Tipped Screwdriver
Cross-Tipped Screwdriver
Socket Head Wrench Set
SUPPLIES: Idler Rollers
Drive Roller
Printer Belt Set
Unplug power cord before servicing machine. Death
or injury may result from failure to comply with this
warning.
a Power OFF.
b. Unplug power cord.
c. Turn captive screws on right and left covers and remove,
d. Remove exhaust blower (1) from left end of machine by removing two wing nuts (2)
and disconnecting motor connector (3).
Change 4
5-17
