TM 5-3610-256-14
s. Be sure developer screen is aligned.
t. Reinstall developer roller.
u. Reinstall developer tank and plate. Secure with three screws.
v. Reconnact heater wires and temperature probe.
w. Reconnect tubing.
x. Reinstall developer roller drive sprocket. Hold with setscrew.
y. Adjust chain tension by pulling drive sprocket downward until chain tension is the same as
n step f, above. Tighten four screws to hold tension.
z. Reinstall exhaust blower bracket.
aa. Reinstall exhaust blower and secure with wing nuts.
ab. Reinstall right end left covers. Secure with captive screws.
ac. Plug in power cord.
ad. Power ON.
ae. Perform operational check.
5-10. MAINTENANCE OF DRIVE CONTROLLER.
TOOLS: Flat-Tipped Screwdriver
Cross-Tipped Screwdriver
Stopwatch
SUPPLIES: Drive Controller
Unplug power cord before servicing mechine. Death
or injury may result from failure to comply with this
warning.
a. Power OFF.
b. Unplug power cord.
c. Remove right cover by turning captive screw.
Change 1
5-13
