TM 5-3610-256-14
i. Disconnect heater wires ( 1 ) from developer tank.
j. Disconnect temperatu re probe ( 2).
k. Remove six screws (3) securing left and right developer tank end plates. Remove sealant.
l. Note position of developer roller and screen. Then remove developer roller and screen.
m. Remove polyester pick-offs. Scrape gently to remove remaining double sided tape.
n. Install new pick-offs. Secure with double-sided tape.
o. Remove and discard end gaskets and grommets. Remove all traces of sealant from tank and end
plates.
p. Replace gaskets and grommets
q. Coat developer tank shell and end plate surfaces where sealant was removed with fresh sealant.
Then replace right developer tank end plate and secure with three screws.
r. Place new developer screen in position. Be sure smooth surface of screen will contact
roller.
5 - 12
