ITEM NO.
1
TM 5-3610-256-14
Table 4-1. Direct Support Lubrication Instructions (Continued)
INTERVAL
ITEM TO BE LUBRICATED
PROCEDURE
DRIVE MOTOR (CONTINUED)
h. Remove four screws (1) and Iockwashers (3) to
separate end case (3) from drive motor (4).
i. Lubricate drive gears (5).
j. Install end case (3) on motor (4) and secure with
screws (1) and lockwashers (2).
k. Reinstall motor and place sprocket on shaft. Secure
the gear by tightening socket head setscrew
over the flat portion of the shaft.
l. Connect leads to motor,
m. Replace four screws and washers. Pull motor
downward to restore chain tension. Tighten
screws
n.
o.
P.
q .
r.
Reinstall rear cover and secure with screws.
Reinstall left cover and turn captive screw.
Plug in power cord.
Power ON.
Perform operational check.
Change 1
4-3
