c.
Inspection. Refer to paragraph 6-2 c for general inspection procedures.
d.
Repair or Replacement. Refer to paragraph 6-2. d. for general repair or replacement procedures.
e.
Assembly. To assemble the parking brake lever and cross-shaft assembly, proceed as follows:
(1)
Assemble two jam nuts (1, Figure 7-12) onto pull rod (3). Assemble coupler (2) to short threaded and of pull rod
(3) and screw the other end of the rod (3) into clevis (4) Assemble rod & clevis to cross-shaft lever arm (7) and
secure using clevis pin (6) and cotter pin (5).
(2)
Position the parking brake lever and cross-shaft assembly (Figure 7-12) underneath the trailer frame and loosely
attach the parking brake lever and cross-shaft assembly (7) to the trailer frame with its mounting hardware Put the
cross-shaft pillow block on the end of the cross-shaft, and secure to the bottom of the frame with the pillow block
mounting hardware. Tighten lever arm hardware.
(3)
Attach parking brake cable (18, Figure 7-9) to coupler (2, Figure 7-12), adjust parking brake tensions and tighten
jam nuts (1).
6-19.
BRAKE ASSEMBLY (See Figure 7-10): The following paragraphs contain disassembly, cleaning, inspection,
repair or replacement and assembly instructions for the trailer unit brake assembly.
a.
Disassembly. Disassemble the brake assembly only to the extent necessary to repair or replace a defective part
or parts.
(1)
It is not necessary to remove brake assembly hardware (15, 16, 17 Figure 7-9) to disassemble the brake
.assembly. Remove for replacement purposes.
(2)
Disassemble the brake assembly (Figure 7-10) in the order of the assigned index number (Figure 7-10). Use
brake spring pliers to remove and install springs (2).
b.
Cleaning. Refer to paragraph 6-2. b. for general cleaning procedures.
c.
Inspection. Refer to paragraph 6-2. c. for general inspection procedures.
d.
Repair or Replacement. Refer to paragraph 6-2. d. for general repair or replacement. procedures.
e.
Assembly. Assemble brake assembly (Figure 7-10) min the reverse of disassembly (See paragraph 6-19. a. ).
6-20.
TEST: The following contain the information for testing a system (s) component (s) on the CT-1 Commercial
Trailer Unit.
a.
Refer to Section IV, paragraph 4-3 and proceed as required.
6-18
