TM 5-4940-200-35
c. Cleaning, Inspection, and Repair.
d. Reassembly.
(1) Clean all metal parts, except bearings, in
(1) Refer
an approved cleaning solvent and dry
model
SECM power takeoff.
thoroughly.
(2) Refer
model
CMU-5 power takeoff.
(3) Inspect all metal parts for cracks or
e. Installation.
breaks.
the power takeoff.
(4) Inspect the pulley for nicks, wear, burs, or
cracks. Smooth all burs and minor nicks
f. Adjustment. Refer to TM 5-4940-200-12 and
with a file. Replace a defective pulley.
adjust the power takeoff clutch.
(5) Inspect the hub and back plate, floating
plate, and roller disk for cracks, breaks,
39.
Clutch Operating Linkage Bracket Assembly
galled bearing surfaces, rough bearing
surfaces, and excessive wear. Replace a
defective hub and back plate, floating
the clutch operating linkage bracket assembly.
plate, or roller disk.
(6) Inspect all gears for excessive wear,
b. Disassembly.
nicks, and cracks. Replace a damaged
disassemble the clutch operating linkage bracket
gear.
assembly.
(7) Inspect the adjusting yoke, lever pin,
lever, roller, and lever spring for cracks,
c. Cleaning, Inspection, and Repair.
breaks, excessive wear, or other damage.
Replace if defective.
(1) Clean all parts in an approved cleaning
(8) Inspect the clutch cover for cracks,
solvent and dry thoroughly.
breaks, or dents.
(2) Inspect all parts for cracks, breaks, or
(9) Hammer out dents in the clutch cover.
excessive wear.
Discard a cracked or broken clutch cover.
(3) Replace all worn or defective parts.
(10) Inspect the cone sleeve for burs, nicks,
galls, and excessive wear. Replace a
d. Reassembly. Refer to
figure 21 and reassemble
damaged cone ring or cone sleeve.
the clutch operating linkage bracket assembly.
(11) Inspect the cone collar for excessive wear,
cracks, or breaks. Replace a defective
cone collar.
the clutch operating linkage bracket assembly.
(12) Inspect the pillow blocks for excessive
wear, cracks, or breaks.
Replace a
40.
Power Takeoff Upper Linkage
defective pillow block.
(13) Inspect all V-belts for wear, cracks, and
a. Removal.
Refer to TM 5-4940-200-12 and
fraying. Replace defective V-belts.
remove the model SECM or model CMU-5 power takeoff
upper linkage.
b. Disassembly.
power takeoff upper linkage, model
SECM.
36