TM 5-4940-200-35
1
Companion flange
8
Straight lubrication fitting,
2
Retaining ring (8 rqr)
1/8-27 in.
3
Needle roller bearing (8 rqr)
9
Female yoke
4
Cork seal (8 rqr)
10
Lubricating fitting 67, 1/8-27
5
Retainer seal (8 rqr)
in. (2 rqr)
6
Universal joint cross (2 rqr)
11
Universal joint spider (2 rqr)
7
Male yoke
12
Hub yoke
Figure 18. Power takeoff universal joint and shaft, disassembly
and reassembly.
Section V. POWER TAKEOFF AND POWER TAKEOFF CONTROLS
37.
General
38.
Power Takeoff
The power takeoff, located at the front of the body below
a. Removal.
the floor, is mounted on crossmembers through pillow
the power takeoff.
blocks. Power is transmitted from the truck engine to the
power takeoff and from the power takeoff through drive
b. Disassembly.
belts to the generator-welder. The power takeoff has a
clutch which, through a linkage system, can be
(1) Refer
disengaged to shut off power to the generator-welder. It
Model
SECM power takeoff.
is protected from road dirt and water by a shield.
(2) Refer
Model
CMU-5 power takeoff.
33