TM 5-4940-200-35
23
Right side compartment
29
Shelf divider (2 rqr)
assembly
30
Lower shelf, right rear
24
Drip ledge (2 rqr)
compartment
25
Rivet, aluminum, 1/8 IN.
31
Right wheelhousing
x 5/16 in. (56 rqr)
panel
26
Shelf (6 rqr)
32
Short drip ledge (2 rqr)
27
Shelf support (18 rqr)
33
Rear body crossmember
28
Tank retainer
Figure 31-Continued.
brackets, cylinder rack assembly, striker
(7) Refer to paragraph 29 and remove the
plates, door moulding and seal, gage
engine overspeed relay (model SECM).
compartment door, hose bracket, control
(8) Refer to figure 31 and disassemble the
panel screen, cylinder guide, and hinged
model
SECM
shop
set
body.
roof panel.
Disassemble the model CMU-5 shop set
(2)
Refer to paragraph 23 and remove the
body in a similar manner.
control panel.
(3)
Refer to paragraph 21 and remove the
c. Cleaning, Inspection, and Repair.
power takeoff.
(4)
Refer to paragraph 22 and remove the
(1) Clean the shop set body with a steam
generator-welder.
cleaner to remove all dirt, oil, and dust.
(5)
Refer to paragraph 49 and remove the
(2) Inspect each compartment for loose rivets,
battery-charging
resistor
box
and
dents, cracks, holes, or other damage.
resistors.
(3) Repeen or replace all loose rivets,
(6)
Refer to paragraph 51 and remove the
straighten dents, weld cracks or breaks,
electrical receptacle boxes and cables.
and patch and weld holes.
59
