TM 55-4920-212-15
CHAPTER 8
OPERATING INSTRUCTIONS (FIELD AND DEPOT
MAINTENANCE)
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
designed to fit and hold particular tools may be inserted
147. General
in drawers. This is to protect tools, to make finding
Shop sets, when received, are to be unloaded, uncrated,
them easier, and to hold them securely during transit.
depreserved, and inspected by field and depot
Drawers and open bins are numbered from 1 to 11
maintenance personnel.
chronologically from top to bottom in rows,
counterclockwise around the interior of the shop, starting
148. Unloading and Uncrating New Equipment
at the right rear.
a. Unloading. Remove shoring, blocks, tiedowns,
Tool and Equipment Drawer Location Semitrailer
and chocks before unloading equipment.
Mounted, C-3, Flaw Detection
Warning: Remove nails and loose
strapping from unloading area.
Storage
Caution: Lift only at hoisting points
Drawer
Nomenclature
Total
provided when equipment is to be
No.
unloaded from heights above ground
1 Apron, battery workers, cotton-twill
3
level (TM 9-2330-23814).
2 Cleaning gun, pneumatic
2
2 Coupling half, quick disconnect, female
4
b. Uncrating and Servicing New Equipment.
fluid connection end
Uncrating and servicing procedures normally will be
2 Coupling half, quick disconnect, male 4
those outlined in paragraphs 72. Additional information
fluid connection
required for unloading specific item are contained in the
1 Faceshield, industrial plastic mask.
2
technical manual for the item.
7 Field indicator, pocket size, magneto-
1
c. Depreservation. Procedures for depreservation
meter
of new equipment normally will be as outlined in
1 Gloves, rubber, men's synthetic
8
2 Gun, air blow, straight design
2
d. Removal of Compound and Devices. Remove
11 Hose, rubber, air, 25 ft. Ig.
2
11 Hose, water, 50 ft. Ig. w/coupling
1
rust preventive compounds, protective grease, or other
6 Light, extension, 100 ft. lg.
2
coatings from new parts prior to installation. Prepare
w/explosion proof globe.
new parts by presoaking or by other methods as
7 Magnifier, glass, 5 in. focus
2
necessary.
Lubrication of new parts will be as
7 Mirror, inspection (snap-on GA--51)
2
prescribed in the appropriate lubrication order.
2 Nipple, pipe, brass 1/4 in.
2
3 Oil gun, pneumatic, 32-oz. cap.
1
149. Installation
a. Location of Handtools. Following is a typical
alphabetical listing of the location of common tools and
b. Location of Mounted Equipment.
In some
equipment in drawers and storage cabinets provided.
instances, tools, equipment, or instruments are mounted
Cutout sections,
on walls, floor, or benches of the shop. These items are
either too large for cabinet storage, or their use makes
cabinet storage
55
