TM 55--4920-217-15
to an external power receptacle mounted at the right rear
space provided when not in use. Wipe foreign materials
exterior corner of the shop.
The external power
from electrical receptacles before use or when exposed
receptacle feeds directly to the safety disconnect switch,
to wind, dust, rain, snow, or salt water.
c. Adjustments.
Check all male electrical
and t' en to the control panel. The electrical panel
contains 14 thermal-magnetic circuit breakers for
connectors for security and condition before use. Adjust
supplying power to the various circuits. The wiring
or tighten terminals as necessary. Female electrical
diagram for the shop set C-8, is contained in figure 8.
connectors and receptacles require few adjustments
beyond the tightening of screws. Check all female
electrical connectors, and receptacles for security and
46. Electrical Wiring Installation
condition before use.
a. General. Operator maintenance of the electrical
Warning: Disconnect the power source at
wiring installation consists of service and adjustments.
the external power receptacle prior to
b. Servicing. Keep electrical power cords clean
adjusting female electrical connectors or
and free of grease and oil. Do not allow rubber covered
power cords to come in contact with cleaning solvents or
receptacles.
paint thinners. Store detachable electric power cords in
Figure 8. Wiring diagram, shop set C-8.
17
