TM 9-243
USING A TUBING BENDER
1 Raise slide bar (1) and insert tubing (2) to be bent.
5 Stop bending the tubing when the zero mark on the
2 Raise locking clip (3) and lock tubing in place.
slide bar matches the desired angle (6) on the block.
3 Lower slide bar. The zero mark (4) on the slide bar
6 Raise the slide bar (1), lift up the locking clip (3), and
should match up with the zero mark on the block (5).
remove the bent tube (2).
4 Apply downward pressure on the slide bar.
40-3
