TM 9-243
USING AN ELECTRICAL CONDUIT HAND BENDER
1 Install handle (1) on bender (2). A section of
threaded pipe may be used as a handle.
2
Tip the bender forward and slide the section of
conduit (3) to be bent through the retaining hook (4).
3 Place mark where bend is to start opposite the arrow
on the front end of the bender.
CAUTION
Do not jerk the handle, as this will
create internal cracks and ridges
inside the conduit which will cut the
wires.
4 Place one foot on the foot rest (5) and push down
with your foot while pulling back on the handle.
Apply steady pressure throughout the entire bending
process.
5 When desired bend has been obtained, release the
pressure on the conduit by returning the handle to
an upright position and slide the conduit out of the
bender.
CARE OF BENDERS
1.
Clean all grease and oil from gripping surfaces with
a rag.
2. Apply a light coat of oil to non-gripping surfaces.
3. Store in a safe, dry place.
40-4
