TM 9-4933-223-13&P
13-15. SHOP SET--DOOR MODIFICATION--MAINTENANCE INSTRUCTIONS (cont)I
DISASSEMBLY (cont)
NOTE
CAUTION
Each blind insert is installed in a
Do not remove blind inserts
large hole which has two small
unless
necessary
for
holes on each side of it. These
replacement.
three holes must be drilled clear
of cured adhesive as described
in steps 10 and 11 below.
9
FOUR BLIND INSERTS (12). Remove
by drilling out with a 0.375-in. (0.953-
cm) diameter drill.
This procedure pertains to each
blind insert to be removed.
10 LARGE HOLE (13). Drill a 0.391-in. (0.993-cm) diameter hole 1.50
in. (3.81 cm) deep.
11 TWO SMALL HOLES (14).
a. Drill a 0.125-in. (0.318-cm) diameter hole 0.25 in. (0.64 cm)
deep.
b. Insert a 0.062-in. (0.157-cm) diameter drill and drill a hole at an
angle to intersect the large hole (13).
3-152