TM 9-4933-223-13&P
3-33. WIRE ASSEMBLY--MAINTENANCE INSTRUCTIONS (cont)
INITIAL SETUP:
NOTE
General Safety Instructions
There are six wire assemblies tagged no.
WARNING
1, no. 2, no. 3, no. 4A, no. 6A, and no.
De-energize shop set by placing circuit
7 used in connecting the S7/S8 switchbox
breaker on power distribution panel
assembly to the circuit breaker panel box
connected to power source in OFF position
PL1. Each assembly consists of one
and then disconnect 120/208V cable
30.00-in. (76.20-cm) stranded black wire
assembly from shelter.
with a lug terminal at one end. Refer to
wire table 3-2. The following procedures
are written for quantity of one wire
assembly, and must be repeated for the
other five wire assemblies.
REMOVAL
INPECTION
1
LUG TERMINAL (1). Check for missing, damaged, or
Refer to the disassembly procedures
corroded parts.
2
WIRE (2).
a. Check for damaged insulation.
b. Check for broken conductor.
3-254
