TM 9-4940-421-14
O R G A N I Z A T I O N A L MAINTENANCE INSTRUCTIONS
Section I. SERVICE UPON RECEIPT OF MATERIAL
CAUTION
EQUIPMENT.
Do not change loading plan of set con-
tents (app E). Relocation may result In
a. Perform daily preventive maintenance services
damage to Test, Measurement, and
Diagnostic Equipment (TMDE) Items
b. Refer to truck manual for servicing chassis.
due to vibration.
c. Make a complete inspection of the shop set and the
i. Visually inspect that all shop set contents in
equipment, visually inspecting for loss or damage which
their respective locations and secured with hold down
may have occurred during shipment.
straps and clamps. Refer to Appendix E for proper loca-
d. Inspect the doom, tailgate and other body mem-
tion of equipment.
bersfordents,breaks, cracks, and loose or missing parts.
4-2. INSTALLATION.
WARNING
cracks and loose or missing parts.
Injury or death can result if shop set is
not properiy grounded.
or missing parts.
For installation instructions, see paragraph 2-6b and c.
g. Inspect the engine for dents, defects and for loose
or missing parts.
h. Correct any deficiencies or refer them to Direct
Support Maintenance.
Section II. MOVEMENT TO A NEW WORKSITE
and air compressor are secure.
a. Disconnect all welding cables and stow securely
d. Make certain all compartments are securely
in the proper compartment.
latched and locked.
b. Secure all portable accessories in the proper loca-
tion withhold down straps.
Refer to paragraph 4-2.
Section III. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
Repair parts are listed and illustrated in the repair parts
No special tools or equipment are required by organiza-
and special tools list covering organizational mainte-
tional maintenance personnel for the maintenance of
-
nance for this equipment TM 9-4940-421-24P.
this shop set.
Section IV. LUBRICATION INSTRUCTIONS
3-1 for lubrication information.
