TM 9-4940-421-14
OPERATOR/CREW MAINTENANCE INSTRUCTIONS
Section I. LUBRICATION INSTRUCTIONS
b. Clean fittings before lubrication.
3-1. GENERAL. This section
contains lubrication
instructions for the shop set. No lubrication order has
c. After washing or fording relubricate affected
been published. Refer to table 3-1 for lubrication infor-
p .a r t s
-
mation.
d. Care of lubricants and lubrication equipment.
3-2. LUBRICATION INFORMATION.
Keep all lubricants in closed containers and store in a
clean, dry area away from heat. Do not allow dirt, dust,
a. Intervals are based on normal operation. Reduce
water, or other foreign material to come in contact with
intervals to compensate for abnormal operations and
the lubricants. Keep all lubrication equipment clean and
severe conditions. During inactive periods sufficient
ready for use.
lubrications must be performed for adequate preserva-
tion.
TABLE 31. LUBRICATION
Intervals
Temperature
Capacity
Lubricants
above +40F +40 to +l0F +10 to -10F
OES
OE 10
OE 30
0E-OIL, Engine, Heavy Duty
50 hrs.
5 qts
1/2 qt.
Filter
3 months
3/4 pt.
see note 1
Oil can points
50 hrs.
OES-OIL, Engine Subzero
all temperatures
GAA-GREASE, Automobile and
artillery
6-8 months
1 oz.
see note 2
NOTES
1. Oil Can Points. Every 50 hrs. lubricate the hinges, latches linkage and exposed adjusting threads with OE.
Section II. OPERATOR/CREW PREVENTATIVE MAINTENANCE CHECKS AND SERVICES
c. If Your Equipment Fails to Operate. Troubleshoot
with proper equipment. Report any deficiencies using
a. Before You Operate. Always keep in mind the
the proper forms. See DA PAM 738-705.
CAUTIONS and WARNINGS. Perform your
3-4. PMCS PROCEDURES.
"BEFORE" PMCS prior to the equipment leaving its
containment area or performing its intended mission.
a. Your Operator/Crew Preventive Maintenance
Checks and Services table (table 3-2) lists the inspec-
b. While You Operate. Always keep in mind the
tions and care of your equipment required to keep it in
CAUTIONS and WARNINGS. Perform your
good operating condition.
"DURING" PMCS when the equipment is being used in
its intended mission.
Change 1