PANEL ASSEMBLIES.
3-18.
a. General. The panel assemblies are stacked on top of the left
and right workbench.
Unfasten four straps and remove two panel
assemblies .
Installation.
Reverse the procedures in b. above.
c.
ACTUATOR TEST STAND ASSEMBLY.
a. General.
The test stand is located to the left of the front
workbench.
b. Removal. Refer to figure 14 and unfasten straps (1 & 2) to
remove the actuator test stand assembly.
c. Installation.
Install the test stand in reverse order of
removal, b. above.
Actuator Test Stand.