Section VI.
DATA PLATES AND FRONT WORKBENCH
FRONT WORKBENCH.
a. General. The front workbench is located in front of the two
center workbenches.
b.
Removal.
Remove two stools and three pails (para 3-6) and one
(1)
(2)
Remove the test set, low voltage circuit, and two pen
(3)
(4)
Remove the thread cutting tap set and electrical insu-
(5)
Disconnect electrical receptacle and conduit from work-
bench.
Refer to figure 23 and remove six screws and six wash-
(6)
ers.
(7)
Remove eight screws (6) and eight washers (7) and re-
move workbench.
c.
Cleaning, Inspection and Repair.
(1) Clean all metal parts with cleaning solvent (P-D-680)
and dry thoroughly. Clean other parts with a clean dry
cloth.
(2) Inspect for dents, nicks and burrs, cracks, breaks and
other damage.
(3) Remove distortions or replace damaged items. Replace
missing hardware.
Install the front workbench in the reverse
d. Installation.
order of removal b. above.