TM 9-4940-549-14&P
Remove the radiator cap.
a.
Do not add coolant to an overheated en-
gine unless it is running.
Add coolant as required. Leave coolant level approximately 2 inches
b.
below the Overf]ow pipe to allow for expansion.
LUBE OIL FILTER.
Service as follows:
Thoroughly clean the oil filter housing and the surrounding area.
drain plug and allow; the oil to drain into a suitable con-
the center bolt and sealing washer.
cap , gasket , spring and filter element from filter body.
gasket and filter element.
Install new filter element into filter body.
Install
bolt .
Install
AIR COMPRESSOR INLET FILTER. Service as follows:
NOTE
Clean off
four pads
Wash pads and disc
Wash inside of the filter body and wipe dry .
and blow dry with compressed air.
Inspect pads for excessive wear or loss of capacity to retain dust or
dirt. Replace defective pads.
Secure pads
Position disc in body, then stack four pads in body.
in body with the remaining disc.
