TM 9-4940-549-14&P
BODY ENCLOSURE COMPONENTS.
The enclosure includes a large hydraulically-operated door
General.
a.
on each side of the body that opens to form an extended roof. Two
lower doors on each side manually open downward to level position
for use as extended floor area and as work benches. There is a
personnel door at the rear of the body. The entire rear panel as-
sembly is latched at the bottom and opens upwards to the horizontal
position so that the tent frame and enclosure canvas may be used.
The engine and dynamotor-welder housing has two doors on each
side for access to the engine; a small door on the left side for ac-
cess to the power receptacles and an inspection door on the street
side retained by screws.
Tent Frame.
b.
(1) Removal. Loosen the straps that secure the tent frames to the
roof of the van body and remove the tent frames.
(2) Cleaning and Inspection.
(a) Clean all parts with cleaning solvent and dry thoroughly.
(b) Inspect all parts for bends, cracks and other defects.
(c) Installation. Install the tent frames in their stowed po-
sition on top of the van body and secure with eight retain-
ing straps.
Canvas Walls, Roofing and Deflector.
c.
(1) Removal.
Remove the tent canvas from the shop set.
NOTE
Identify folded canvas so that they
are refolded in the same way.
(2) Cleaning and Inspection.
(a) Clean all parts with warm water and soap and dry thoroughly.
(b) Inspect the canvas for tears, open seams and improperly
attached grommets and straps. Repair a defective canvas
in accordance with FM#10-16.
(c) Installation.
Fold and store the tent canvas in the shop
set.
d.
Utility Ladders.
(1) Removal. Remove the ladder from its stowed position on the
right side of the enclosure. Then remove the two ladders from
their stored positions, inside the shop set on both sides at the
rear.