TM 9-4940-549-14&P
REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
ENGINE ENCLOSURE.
Removal.
a.
(1) Remove the ladder from its stowed position on the right side of
the engine enclosure.
(2) Disconnect the shutter control cable from the shutter assembly
and remove the four clamps securing the cable to the enclo-
sure.
(3) Remove the muffler.
(4) Drain and remove the fuel tank assembly(para 8-2).
(5) Disconnect the front clearance lights at the trailer wiring har-
ness.
(6) Refer to figure 5-1 and remove the four nuts (1), four washers
(2), and four screw (3) that secure the engine housing to the
trailer frame.
(7) Attach a suitable lifting device to the engine housing (4).
(8) Move the engine housing (4) forward until the housing (4) is
free to move upward.
(9) Lift away the engine housing (4).
b.
Installation (Refer to figure 5-l).
Use a suitable lifting device and lower the engine housing (4)
(1)
into position.
(2)
Secure the engine housing (4) to the trailer frame with four
screws (3), four washers (2), and four nuts (1).
(3)
Connect the front clearance lights to the trailer wiring harness.
(4)
Install the fuel tank assembly (para 8-2).
Install the muffler.
(5)
Install the ladder to its stowage position on the right side of
(6)
the engine enclosure.
Connect the shutter control cable to the shutter assembly and
(7)
secure the cable to the enclosure.
