TM 9-4940-549-14&P
ENGlNE.
Removal.
a.
(1) Remove the engine enclosure.
(2) Remove the battery box.
(3) Disconnect the sending units.
(4) Disconnect all cables and lines.
(5) Remove the screws (fig. 5-2) that secure the engine.
(6) Use a suitable lifting device and move the engine forward to
clear the clutch housing.
(7) Lift away the engine.
Installation.
b.
(1) Use a suitable lifting device and lift the engine into position.
(2) Refer to figure 5-2 and install the screws that secure the en-
gine.
(3) Connect all cables and lines.
(4) Connect the sending units.
(5) Install the battery box and engine enclosure.
5-3. DYNAMOTOR-WELDER.
a.
Removal.
(1) Remove the engine enclosure.
(2) Remove the engine.
(3) Tag and disconnect all electrical wiring.
(4) Refer to figure 5-2 and remove the four screws.
(5) Use a suitable lifting device and remove the dynamotor-welder.
b.
Installation.
(1) Use a suitable lifting device and place the dynamotor-welder
into position.
(2) Refer to figure 5-2 and install four screws.
(3) Connect the electrical leads per tagged identification.
5-3
