TB 9-4940-302-30
INSTALLATION IN 280 SHELTER
Section II.
d. Fabricate eight brackets (7551851)
Installation
in accordance with figure 7.
NOTE
Follow steps (1) thru (16) below
Hand blind riveter (5120-00-
for equipment installation in the 280
679-6523) is used for instal-
shelter, unit 1.
ling blind rivet nuts in
floor and walls of the 280
(1) Position storage cabinet
shelter. Hand blind riveter
(7125-00-330-0130) in left front
(5120-00-357-6065) is used
corner in accordance with figure 2.
for installing blind rivets
Mark and drill two 0.34-in. diameter
Install blind
(MS20601).
holes through storage cabinet bottom
rivet nuts in accordance
plate. Locate holes at the two corners
with MIL-N-47187.
allowing for minimum required clearance
for 5/16-in. hex head capscrews.
Position storage cabinets,
14-in. bed and 30-in. bed
Secure storage cabinet to floor-mounted
blind rivet nuts using two 5/16-in.
industrial sewing machines,
lockwashers (MS35338-45) and two 5/16-
first aid kit, and fire
x 1-in. hex head capscrews (MS90725-
extinguisher as shown in
34).
equipment mounting holes as
template for location of
(2) Using support angle (11021151-
blind rivet nuts. Positions
4) as a template, mark and drill two
0.19-in. diameter pilot holes, 2-1/2
may be varied to drill into
structural members in fixed
inches from each end of support angle,
floor.
into storage cabinet top in accordance
with figure 2. Position support angle
a. Follow steps (1) and (2) below
and secure to wall-mounted blind rivet
nuts using two 5/16-in. lockwashers
for installing blind rivet nuts in the
(MS35338-45) and two 5/16- x 1-in. hex
280 shelter, unit 1.
head capscrews (MS90725-34). Secure
support angle to storage cabinet using
(1) Mark and drill eight 0.25-in.
diameter holes in floor and walls of
two 5/16-in. lockwashers (MS35338-45)
shelter in accordance with figures 3
and two 5/16- x 1-in. hex head lag
and 4. Install eight #10 blind rivet
bolts (MS16992-520).
nuts (MS27130-A23).
CAUTION
Remove storage cabinet
(2) Mark and drill sixteen 0.41-
drawers adjacent to hole
in. diameter holes in floor and walls
in accordance with figures 3, 4, and 5.
locations before drilling.
Install sixteen 5/16-in. blind rivet
nuts (MS27130-S45).
(3) Using strap loop (MS51939-3)
as a template, mark and drill two 0.19-
b. Install a strap loop (MS51939-3)
in. diameter holes in metal side of
in floor using two #10 x 1-in. counter-
storage cabinet in accordance with
sunk head machine screws (MS35190-275)
in accordance with figures 2 and 3.
storage cabinet using two 3/16-in.
blind rivets (MS20601-MP6W2).
Fabricate two support angles
(11021151-4) in accordance with figure
6.
