TM 5-3610-256-14
MACHINE MANIFOLD
EXHAUST BLOWER BRACKET
NUT
WASHER
AIR DUCT
SPACER
FELT SEAL
THREADED STUD
d. Remove the blower assembly (1) by removing wing nuts (2) from threaded studs (12). Disconnect
electrical connector (3).
e. Remove screws (4) to remove machine manifold (5). Inspect for dents which may impair operation.
Replace as required.
f. Remove exhaust blower bracket (6), nut (7), washer (8), air duct (9) and spacer (10). Replace felt seal
(11) as required. Secure with cement.
g. Reinstall air duct (9), washer (8), nut (7) and exhaust bracket (6).
h. Reinstall machine manifold (5) and secure with screws (4).
i. Reinstall electrical connector (3). Reinstall blower assembly (1) and secure with wing nuts (2).
j. Reinstall left cover and turn captive screw.
k. Plug in power cord.
l. Power ON.
m. Perform operational check.
Change 4
4-19
