(2)
Remove three cap screws (8) attaching
solenoid (1) to drive end frame (27).
Remove solenoid (1) from frame (27).
(3)
Unscrew and remove socket head screws
(10) attaching cap (9) to commutator end
cap (12). Remove washer, retainer ring,
washer, and shim (11) from end of
armature (26) shaft.
(4)
Remove one hex nut (14) and flat washer
(15)
from
each
stud
(13).
Detach
commutator end cover (12) from field
winding housing (31). Using a pair of wire
pliers, or equivalent, bend field winding (32)
brush (18) holder tabs on brush holder (19)
and remove two springs (17) and two
brushes attached to field winding (32).
Remove brush holder (19) with two brushes
(18) from armature (26) shaft. If brushes
(18) are worn, bend brush (19) holder tabs
and re-move springs (17) and brushes (18).
CAUTION
If insulating tubes over studs (13) are present, care
should be taken while pulling frame (27)
Figure 6-13. Removing Retainer from Snap Ring
with attached studs (13) and armature (26) from housing
(31).
(5)
Pull frame (27) with studs (13) and
armature (26) from housing (31). Unscrew
studs (13) from frame (27). Unscrew and
remove nut (23) washer (24) and screw
(25) from frame (27). Pull frame (27)
forward, also pulling out lever (22). Hold
armature (26) slanting downward and slide
lever (22) upwards, disengaging the lever
(22) from the guide rings on pinion (20).
Remove the armature (26) and lever (22)
from frame (27).
(6)
Separate bearing ring (11) from snap ring
(11) on the drive end of the armature (26)
shaft, using an extra deep 5/8" socket. See
Figure 6-13. Remove snap ring from
armature (26) shaft. See Figure 6-14.
(7)
Remove
pinion
(20)
and
intermediate
bearing (29) from armature (26) shaft. Do
not remove windings (32) unless it is
necessary. If bearings (21, 28 or 30) are
worn or damaged, press bear-ings from
pinion (20), frame (27) or bearing (29).
Figure 6-14. Removing Snap Ring from Armature
6-53
