TM 5-4310-381-13
REMOVAL.
CAUTION
To avoid equipment damage, compressor must be shut down before
performing maintenance procedures.
a. Drain gasoline at drain plug (1) and fuel pump filter fitting (2) into suitable container (maximum: 2.1 gals., 8 L).
b. Remove hose (3) from tank fitting (4).
c. Remove nuts (5), lockwashers (6), washers (7), and capscrews (8) securing tank straps (9) to frame.
d. Remove fuel tank (10).
e. Remove rubber shims (11) from fuel tank.
f.
Remove tank fitting (4) from tank.
g. Remove hose (3) from fuel pump filter fitting (2).
REPAIR.
a. Inspect hose (3) for cracks or other signs of deterioration. Replace as necessary.
b. Inspect fittings (2 and 4) for cracks or damaged threads.
c. Inspect tank seams for signs of damage. Clean and scrape any loose or peeling paint on tank. Bare metal must
be primed and repainted.
d. Check cap gasket (12) for wear. Replace as necessary.
WARNING
Clean with compressed air no greater than 30 psi. Protective eyewear
must be worn when using compressed air.
e. Check strainer (13) for any wear in mesh. Clean strainer of any accumulated debris by blowing out with
compressed air.
f.
Inspect rubber lining (14) on tank strap (9) for wear. Replace as necessary with any suitable material.
g. Inspect rubber shim (11) for wear. Replace as necessary with any suitable material.
INSTALLATION.
a. Install fuel tank (10) with tank straps (9) and secure with capscrews (8), washers (7), lockwashers (6), and nuts (5).
Make sure that rubber shims (11) are in place before tightening.
b. Install tank fitting (4).
c. Install hose (3) to tank fitting (4) and fuel pump fitting (2).
d. Refill with fuel and check all fittings for leaks before operation.
3-20