TM 5-4310-381-13
REMOVAL.
CAUTION
To avoid equipment damage, compressor must be shut down before
performing maintenance procedures.
a. Place machine on flat level surface. Block wheels if surface is not level.
b. Remove guard and drive couplings. Refer to paragraph 3-18.
c. Remove air pump with air filter assembly and air hose assembly attached. Refer to paragraph 3-19.
d. Remove gas engine from base. Refer to paragraph 3-20.
e. Remove bolts (1) and nuts (2) that secure base (3) and mounts (4) to frame. Remove base and mounts from
frame.
f.
Remove bolts (5) and nuts (6) that secure mounts to base.
g. Inspect rubber mounts (4) for cracks or signs of deterioration. Replace as necessary during installation.
INSTALLATION.
a. Install mounts (4) to base (3) and secure with bolts (5) and nuts (6).
b. Install base (3) to frame and secure with bolts (1) and nuts (2).
c. Install gas engine on base. Refer to paragraph 3-20.
d. Install air pump with air filter assembly and air hose assembly attached. Refer to paragraph 3-16.
e. Install drive couplings and guard. Refer to paragraph 3-18.
f.
Check tightness of all mounting hardware before operation.
3-22
