TM 5-4310-381-13
REMOVAL.
a. Remove nut (1) securing rim (2) and tire (3) from axle (4). Remove rim and tire.
b. Remove four washers (5) used as spacers.
BEARING REPLACEMENT.
a. Inspect the wheel bearings (6) for smooth operation or signs of damage or deterioration.
b. If bearings require replacement, use a suitable bearing puller or bench press to remove bearing from rim.
c. Install new bearing using suitable bench press.
TIRE REPAIR.
a. Inspect the tire (3) for cracked or damaged rubber.
b. Using a soap solution, check for air leaks from the rim (2) and valve (7).
c. If tire (3) is damaged or leaking air, remove from rim (2) and install new tire.
d. Remove wheel valve by driving out of rim hole after tire (3) is removed.
e. Replace wheel valve by driving through rim hole from inside the rim until valve seats.
WARNING
Death or serious injury could occur if compressed air is directed against
the skin. Do not use compressed air for cleaning or drying unless the
pressure is/has been reduced to 30 psi (2.11 kgcm²) or less. When
working with compressed air always use chip guards, eye protection and
other personal protective equipment.
f.
Replace tire and inflate to 30 psi.
INSTALLATION.
a. Install four washers (5) used as spacers between axle (4) and rim (2).
b. Install rim (2) and tire (3) on axle (4) and secure with nut (1). Nut should keep outer race of bearing (6) from
turning.
3-24
