TM 55-4920-217-15
Caution: Do not modify power receptacle or
electrical cable.
10. Pneumatic Controls and Instruments
Pneumatic controls and instruments (fig. 5), are
mounted in the upper left hand rear corner of the shop
interior. The controls and instruments include valves,
regulators, separator, gages, and check units.
Figure 5. Pneumatic controls and instruments.
Section III. OPERATION UNDER USUAL CONDITIONS
11. General
Warning: Use compressed air
Instructions in this section are published for the
only for the purpose for which it is
information and guidance of personnel responsible for
intended.
Serious injuries to
the operation of this equipment. It is essential that the
personnel can result from misuse.
operator know how to perform every operation the
equipment is capable of performing.
d. The equipment comprising Shop Set, Aircraft
Maintenance, Semitrailer Mounted, C -8, Instrument
12. Preparation for Starting
Shop, (par. 4), is now ready for operation.
e. It is essential that the operator(s) be' completely
a. Perform the "before operation" daily services
familiar with the technical manual for the equipment.
b. Assure that all equipment control switches are in
13. Shutdown of Shop Set
the "OFF" position.
c. Connect power supply equipment.
a. Shutdown instructions for the units comprising
Shop Set, Aircraft Maintenance, Semitrailer Mounted,
Note:
Check auxiliary power
C-8, Instrument Shop, are contained in the technical
connections
prior
to
starting
manual issued for
equipment.
8
