TM 9-4940-421-14
Section XVIII. MAINTENANCE OF SHOP BODY COMPONENTS
DOOR, AND REAR DOORS.
NOTE
riveted unit having eight side compartments for tool
Left and right side compartment doors are interchangea-
and equipment storage and a centrally located cargo
ble.
area to the rear of the generator-welder engine. Hinged
the
doors, fitted with locks, are provided for compartment
compartment doors, roof vent door, and rear doors from
closure. A hinged door, located in the roof, is provided
the shop set body.
for air ventilation when operating the engine. A tail-
b. Cleaning and Inspection.
gate, hinged double doors, and roof enclose the genera-
(1) Clean all parts with cleaning solvent and dry
tor-welder engine and air compressor. Various doors
thoroughly (app D).
and compartment fixtures are riveted in place. Any
(2) Inspect the compartment door brace for
maintenance to be performed to these components will
.
cracks, breaks or other damage. Replace a damaged
necessitate rivet removal. Be sure to use the correct size
brace.
and type of rivet when replacing riveted components of
(3) Inspect all hardware for damage. Replace as
the shop set body.
required.
4-49. COMPARTMENT DOORS, ROOF VENT
c. Installation. Install in reverse order of removal.
REMOVE THE REMAINING COMPARTMENT DOORS,
NOTE :
COMPARTMENT DOOR BRACES AND REAR DOORS
IN SIMILAR MANNER.
AR 701562
