TM 1-4920-435-13&P
0049 00
REMOVAL
Remove four bolts Figure 1, Item 2), eight lat washers (Figure 1, Item 3), four lock washers (Figure 1, Item 7),
four nuts (Figure 1, Item 8) and two tubes (Figure 1, Item 5) detaching forming machine (Figure 1, Item 1) from
cabinets (E) and (F) (Figure 1, Item 4).
REPAIR OR REPLACEMENT
1.
If replacing forming machine handle (Figure 1, Item 9), grind off end weld 3.75 inches from the forming
machine handle (Figure 1, Item 9) being sure to cut through both the forming machine handle (Figure 1, Item
9) and handle shaft (Figure 1, Item 6),
2.
Using a No. 3 drill bit, drill a hole centered at end of handle shaft (Figure 1, Item 6) to a depth of 1 inch.
3.
Tap hole using 1/428 at depth of 1/4 inch.
4.
Install one screw (Figure 1, Item 11) and one lat washer (Figure 1, Item 10) attaching forming machine
handle (Figure 1, Item 9) to handle shaft (Figure 1, Item 6).
INSTALLATION
1.
Align bolt holes of sheet metal forming machine (Figure 1, Item 1) and bolt holes on tubes (Figure 1, Item 5)
with mounting holes on cabinets (E) and (F) (Figure 1, Item 4).
2.
Install four bolts (Figure 1, Item 2), eight lat washers (Figure 1, Item 3), four lock washers (Figure 1, Item 7),
four nuts (Figure 1, Item 8) and two tubes (Figure 1, Item 5) securing forming machine (Figure 1, Item 1) to
cabinets (E) and (F) (Figure 1, Item 4).
END OF WORK PACKAGE
0049 00-3/4 blank
