TM 1-4920-438-13&P
0034 00
RELEASING SHELTER WALLS - CONTINUED
8.
Fold in each hinged end wall to roof beam and hold in place with Velcro straps.
LOWERING SHELTER ROOF
WARNING
When all equipment and material are stored in stationary side of shelter, limited loor space
presents a safety hazard to personnel. This is most critical during raising and lowering
of roof panel. Personnel inside shelter could become trapped between roof panel and
equipment bolted to loor. Failure to observe warning could result in SERIOUS INJURY to
personnel.
A minimum of four personnel are required to perform all of the following procedures.
CAUTION
When swinging end wall closed, d-rings on ECU panel should be pressed lat against panel to
prevent damage to hinged roof.
Figure 3.
Lowering Shelter Roof.
0034 00-3