TM 5-3610-256-14
3-8.
3-9.
POWER SOURCE.
The Reproduction Set shall be located within 6 feet (1.8 m) of power source.
For maxim-mm efficiency, the voltage supplied to the machine should be as
close to the prescribed optimum voltage (110 V ac or 220 V dc) as possible.
Serious damage to electrical components may result from extreme high or low
fluctuations. We a standard, two-conductor, grounded receptacle convenient y
close to the rear of the machine.
MACHINE UNCRATING. The Reproduction Set is shipped bolted to a reusable wooden crate.
The machine can be removal from the carton and made ready for installation as follows:
3-10. MACHINE ASSEMBLY. After removing the shipping container, the following steps must be per-
med to ensure proper installation.
TOOLS: Flat-Tipped Screwdriver
Until instructed to do so, do not plug the machine in. Follow
these instructions in the exact order they are presented. Death or
injury may result from ‘failure to comply with this warning.
Change 1
3-5
