TM 55-4920-213-15
OPERATING INSTRUCTIONS (FIELD AND DEPOT MAINTENANCE)
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
inserted in drawers. This is to protect tools,
to make finding them easier, and to hold
Shop sets, when received, are to be un-
them securely during transit. Drawers and
loaded, uncrated, depreserved, and inspected
open bins are numbered from 1 to 48 chrono-
by field and depot maintenance personnel.
logically from top to bottom in rows, counter-
clockwise around the interior of the shop,
133. Unloading and Uncrating
starting at the right rear.
New Equipment
Tool and Equipment Drawer Location Shop
a. Unloading. Remove shoring, blocks, tie-
Set, Aircraft Maintenance, Semitrailer
unloading
downs, and chocks before
Mounted, C-4, Sheet Metal
equipment.
Storage
Warning: Remove nails and loose strapping
drawer
Nomenclature
Total
No.
from unloading area.
Caution: Lift only at hoisting points pro-
Angle Attachment, Drill Chuck
26
vided when equipment is to be unloaded from
1/4 in drive.
1
heights above ground level (TM 9-2330-238-14).
Apron, Blacksmith, Leather,
2
Bib Type.
b. Uncrating and Servicing New Equipment.
20
Adapter, Blind Riveter Head
Uncrating and servicing procedures will nor-
(Olympic)
1
Bar, Bucking, Rivet, Angle Head
3
27
Additional information required for unload-
27
Bar, Bucking, Rivet, "L" head
3
ing specific items are contained in the TM for
Bar, Bucking, Rivet, Universal
27
head
3
the item.
Block & Punch Set
1
27
c. Depreservation. Procedures for depre-
Brush, Dusting, Bench
1
32
servation of new equipment will normally be
Buffing Pad, Lambswool
6
2
Chuck, Drill, 3 Jaw Key Type,
26
d. Removal of Compound and Devices. Re-
1/32 to 1/4 in cap.
1
move rust preventive compounds protective
Clamp C Light, 2 in size,
33
1 3/4 in Throat.
6
grease, or other coatings from new parts prior
Clamp C Light, 3 in size,
33
to installation. Prepare new parts by pre-soak-
1 7/8 in Throat.
6
ing or by other methods as necessary. Lubri-
Clamp C medium, 6 in Size, 2
33
cation of new parts will be as prescribed in
1/4 in Throat.
4
the applicable lubrication orders.
Clamp C heavy,< 2 to 4 in cap,
33
2 3/4 in Throat.
4
Clamp Plier 3 1/2 in w jaw,
33
8 in lg.
2
a. Location of Hand Tool. Following is a
Counterbore Set, Interchangeable
26
typical alphabetical listing of the location of
Pilot Type, 1/4 to 1 in dia.
1
common tools and equipment in drawers and
26
Countersink, High Speed, 1/4 in.
storage cabinets provided. Cutout sections de-
dia., W/3 Straight Flutes,
signed to fit and hold particular tools may be
82o Angle
2