TM 9-4933-223-13&P
13-13. SHOP SET--INSTALLED EQUIPMENT LIST--MAINTENANCE INSTRUCTIONS (cont)
MODIFICATION OF RIGHT TABLE (cont)
1
MACHINIST'S VISE (1). Position on
right table(2) as follows: The front edge
of machinist's vise should be flush with
front edge of table and center line of
vise 7.50 in. (19.05 cm) from cargo
door end of table.
2
RIGHT TABLE (2). Mark location of mounting holes using machinist's vise (1) as a template.
3
MACHINIST'S VISE (1). Remove.
4
RIGHT TABLE (2). Drill four 0.50-in. (1.27-cm) diameter
holes
through
top
at
marked
locations.
3-130
