TM 9494054714&P
(2) The "interval" column tells you when to do a certain check or ser-
vice.
(3) The "location" column tells you where in the shop set the check or
service is performed.
(4) The "procedure" column tells you how to do the required checks and
services. Carefully follow these instructions. If you do not have the tools,
or if the procedure tells you to, have organizational maintenance do the
work.
NOTE
The term "mission capable" means that the equipment is on hand
and ready to performs its combat missions (see AR 700-138) .
(5) The "Not Fully Mission Capable If:" column tells you when the shop
set is non-mission capable and why.
(6) If your equipment does not perform as required, refer to Section 3,
MAINTENANCE INSTRUCTIONS. Report any malfunctions or failures on DA Form
2404, or refer to DA Pam 738-750.
(7) The "Item No. column shall be used as a source of item numbers for
the TM Number column on DA Form 2404, Equipment Inspection and Maintenance
Worksheet, in recording results of PMCS.
Operator/Crew Preventive Maintenance Checks and Services
Table 21.
LOCATION
NOT FULLY MISSION
ITEM TO
ITEM
PROCEDURE
CAPABLE IF:
INTERVAL
CHECK/SERVICE
NO.
Stated PMCS re-
Refer to TM 92330238-
Chassis,
Before
1
quirements are
14&P for PMCS proce-
Semitrailer
not met.
dures .
Refer to applicable
Stated PMCS re-
Heaters
Before
2
quirements are
heater TM for PMCS pro-
not met.
cedures.
Stated PMCS re-
Refer to applicable air
Air Condi-
3
Before
quirements are
conditioner TM for PMCS
tioner
not met.
procedures.
Trailer chassis
Check that ground rod
4
Ground Rod
Before
is not properly
(p. 3-11) is properly
and Wire In-
grounded before
installed and connected
stallation
connecting van to
to trailer grounding
facility power.
terminal before connect-
ing to facility power.
2-2
Change 1
