TM 9-4940-549-14&P
15.3.
UTILITY LADDERS.
Removal. Remove the two ladders from their stowed positions, inside
a.
the shop set on both sides at the rear.
b.
Cleaning and Inspection.
(1) Clean ladders with cleaning solvent and dry thoroughly.
(2) Inspect for damage or defects and replace a defective ladder.
lnstallation.
Install the utility ladders in their respective stowed
c.
positions, as removed. Secure the two ladders with their retaining
straps so they will remain in place while in transit.
DOOR SEALS.
Cleaning and Inspection. Inspect all door seals for cracks, tears,
a.
deterioration, and water or dust leakage. Clean seals with soapy
water and dry thoroughly. Wipe the seals with a silicone compound.
Testing.
If water or dust leakage occurs around seals, darken the
b.
interior of the van body to test for light leaks. Manipulate the seals
to prevent light leakage. Use cellular rubber (sponge) blocks under
the lip of any seal that has become depressed and permits light.
GRINDER.
Remove the grinder as illustrated in figure 15-4.
Removal.
a.
Install the grinder as illustrated in figure 15-4.
Installation.
b.
TAG AND DISCONNECT
NOTE:
ELECTRICAL LEADS.
Grinder, Removal and Installation.
