0038 00
TM 1-4920-436-13&P
NOTE
During installation of components same hardware should be used so as to maintain original
integrity of shop set.
INSPECTION OF INSTALLED ITEMS
Figure 1.
10 Ton Press.
1.
Inspect 10 ton press (Figure 1) and hand pump for damage. Replace as necessary.
2.
Inspect 10 ton press hardware (Figure 1, Item 3, 4 and 5) for rust, cracks and rounded heads. Replace as
necessary.
REMOVAL
1.
To remove 10 ton press (Figure 1, Item 1), remove four bolts (Figure 1, Item 2), four upper lat washers
(Figure 1, Item 3), four lower lat washers (Figure 1, Item 4), four lock washers (Figure 1, Item 5), and four
nuts (Figure 1, Item 6).
2.
To remove hand pump (Figure 1, Item 10), remove two bolts (Figure 1, Item 13) from the front side of the
pump, two bolts (Figure 1, Item 12) from the back side of the pump, four upper lat washers (Figure 1, Item
0038 00-2