0050 00
TM 1-4920-440-13&P
INSTALLATION CONTINUED
ECU POWER CABLE CONTINUED
NOTE
A second person at the cargo door end, guiding and feeding ECU power cable (Figure 3, Item
1) into the ixed roof beam (Figure 3, Item 2), will make the following step, Step 5, easier.
5.
Pull twine/rope through ixed roof beam (Figure 3, Item 2) at circuit breaker box end until correct amount of
ECU power cable (Figure 3, Item 1) is extending beyond end of ixed roof beam (Figure 3, Item 2).
6.
Remove twine/rope.
7.
Pull ECU power cable (Figure 3, Item 1) through box connector and tighten nut (Figure 2, Item 1) after ECU
power cable (Figure 3, Item 1) has been positioned with length (approximately 36 in.) of wire.
8.
Attach ECU power cable (Figure 3, Item 1) wires to circuit breaker (Figure 2, Item 5) with neutral and ground
wires to corresponding terminal strips (Figure 2, Item 3 and 4).
9.
Install circuit breaker panel board and cover onto circuit breaker box (Figure 2, Item 2).
10. Move main circuit breaker to the ON position.
0050 00-6