(4)
Assemble nipple (5), strainer (9), and
valve (4) to body (12).
(5)
Install elbow (2) and elbow (1) in body
(12).
6-27.
Accumulator Assembly (See Figure 8-24). The
following paragraphs contain disassembly, cleaning,
inspection, repair or replacement, and assembly
instructions for the accumulator assembly.
a.
Disassembly. Disassemble the accumulator
assembly only to the extent necessary to repair or
replace a defective part or parts.
(1)
Remove elbow (1), connector (2), tubing
adaptor (3) and bleed valve (4).
NOTE
Refer to bleed valve subassembly
(Section VI) for bleed valve repair
instructions (see Figure 8-26).
(2)
Remove nipple (5), strainer (6), and
connector (7) from accumulator body (10).
NOTE
For detailed breakdown on line strainer
(6) see Figure 8-25.
(3)
See Figure 8-25. Remove plug (5) and o-
ring (6) from strainer body (9). Remove
seal washer (7) and strainer element (8)
from the strainer body (9).
(4)
Remove cap (8) and o-ring (9) from
accumulator body (10).
b.
Cleaning. Refer to paragraph 6-3.a for general
cleaning instructions.
(1)
Wipe out cavity of accumulator body with
lint-free cloth dampened in solvent, per
Federal Specification P-D-680, Type II.
Allow to air dry.
NOTE
For best results, use Ultrasonic Cleaner,
NSN 4’)40-00-164-8977, (Table 2-1),
to clean strainer filter.
(2)
Wash line strainer filter element in solvent,
per 6-34 Federal Specification P-D-680,
Type II1. Allow filter element to air dry.
c.
Inspection. Refer to paragraph 6-3.b for general
inspection instructions.
(1)
Replace a damaged strainer element.
d.
Repair or Replacement. Refer to paragraph 6-
3.c for general repair or replacement instructions.
(1)
Replace all parts damaged to the point of
impairing these normal functions.
e.
Assembly. To assemble the accumulator
assembly, proceed as follows: (1) Install o-ring (9) and
cap (8) into accumulator body (10).
(2)
See "A" Figure 8-25, insert strainer
element (6) and seal washer (5) into
strainer body (7); attach o-ring (4) to plug
(3) and attach plug (3) to strainer body (7).
(3)
Install connector (7, Figure 8-24), strainer
(6) and nipple (5) to accumulator body
(10).
(4)
Attach adaptor (3) to bleed valve (4),
install bleed valve (4) on nipple (5). Install
connector (2) and elbow (1) to
accumulator body (10).
6-28.
Bleed Valve Assembly (See Figure 8-25). The
following paragraphs contain disassembly, cleaning,
inspection, repair or replacement and assembly
instructions for the bleed valve assembly.
a.
Disassembly. Disassemble the bleed valve
assembly only to the extent necessary to repair or
replace a defective part or parts.
NOTE
Note position of elbows (1) prior to
removal.
(1)
Remove elbows (I) and strainers (2).
(2)
Unscrew body plug (3) from strainer body
(7), remove o-ring (4) from plug (3).
(3)
Remove seal washer (5) and strainer
element (6) from strainer body (7).
6-34
