d. Reassembly and Installation. Reassemble and
(3) Remove the filler cap (fig. 4-9) from the
top of the pump and add fluid as necessary in
install the air cleaner as illustrated in figure 3-1.
accordance with the LO 5-4940-225-12. Install and
Refer to LO 5-4940-225-12 for lubrication.
tighten filler cap.
a. General Each side door of the shop set is
a. General. The tent canvas provides a weather-
r a i s e d and lowered by a hydraulic pump and
protected work area when installed on the shop set.
c y l i n d e r . A flow control valve in the system
b. Removal. Remove tent canvas from the shop
provides a metered flow rate and controls the
set.
lowering speed of the cylinder when the control
c. Cleaning and Inspection.
valve lever is placed in the open or return position.
(1) Clean all parts with warm water and soap
b. Adjustment. Adjust the flow control valve as
and dry thoroughly.
illustrated in figure 4-9.
(2) Inspect the canvases for tears, open seams,
c. Cleaning and Inspection.
and loose grommets and straps. Repair a defective
(1) Clean external surface of the pump with a
canvas in accordance with TM 10-269.
cloth dampened in cleaning solvent and wipe dry.
d. Installation. Fold and stow the tent canvas in
(2) Inspect for cracks, breaks, signs of leakage,
the shop set.
and other damage.
