TB 9-4910-744-30
3.
L o c a t i o n of Equipment--Continued
Table 3.
E l e c t r i c a l Components to he Mounted--Continued
Figure
Part No. or
no.
QTY
NSN
Description
40 thru
APPLETON 40-3/4
JUNCTION BOX , LAMPHOLDER :
8
43
t y p e I (W-J-800)
41-42
8
LAMPHOLDER, GENERAL ELECTRIC
GE-5740-7
41-42
8
CONNECTOR RECEPTACLE, GROUNDED:
5935-01-058-9269
2 pole, 3 wire (W-C-596/40)
41-43
SQUARE D
SWITCH BOX (ENCLOSED):
2
D221NRB
s u r f a c e mtd, type NiDS, class
2 , design 2SN BOX, 120/240 Vat, 30 amp
(W-S-865)
43
TERMINAL LUG
MS20659-141
54
(1) Mark and drill twelve 0.25-
Installation
in. diameter holes in front and rear
NOTE
walls in accordance with figures 3, 4,
Hand blind riveter (5120-00-
a n d 5. Install twelve #10-32UNF blind
679-6523) is used for in-
rivet nuts (A10-180).
stalling blind rivet nuts in
the floors and walls of
(2) Install six strap loops
units 1 thru 6.
H a n d blind
(MS51939-3) to installed blind rivet
riveter (5120-00-357-6065)
nuts using twelve #10-32UNF x l-in.
is used for installing blind
c o u n t e r head machine screws (MS35191-276).
r i v e t s (MS20601-Mp6W2) in
storage cabinet wall in unit 3.
b.
Follow steps (1) thru (13) below
Install blind rivet nuts in
for equipment installation in unit 1.
a c c o r d a n c e with MIL-N-47187.
(1) Mark and drill sixteen 0.34-
Unit 1. Follow steps (1) and (2)
in. diimeter holes through horizontal
below for blind rivet nut and strap
leg of factory-furnished, wall-mounted
loop installation.
angle irons in accordance with figure
2.
NOTE
(2) Position two 60-in. tables
Position floor- and table-
(4910-00-543-7772) and two 72-in.
t o p - m o u n t e d equipment as
t a b l e s w/drawers (4910-00-543-7771)
shown in figures 2 thru 5.
under factory-furnished angle iron in
U s e equipment mounting holes
accordance with figures 2, 3, and 4.
as template for location of
Using drilled angle iron as a template,
drilled mounting holes in
mark and drill sixteen 0.22-in. diam-
accordance with figure 2.
12
