Figure 5-10. Clutch Adjusting Yoke Adjustment
Figure 5-11. Clutch Operating Rod Adjustment
c.
Align rod yoke with hole in clutch and lever shaft,
tighten jam nut on clutch operating rod, insert
clevis pin through rod yoke and clutch and lever
shaft; insert cotter pin in clevis pin.
5-16. Air Cooler Subassembly (Figure 1-1). To clean
the outside surface of air cooler, proceed as follows:
Air pressure used for drying or cleaning
shall not exceed 30 psi (206.9 kPa).
a.
Clean outside surface of the air cooler with
compressed air, pressurized hot water and
detergent, or steam.
5-17. Engine Cooling Ducts and Blower Subassembly
(25, Figure 8-30). To clean the engines cooling ribs and
blower, proceed as follows:
a.
Remove air cooling duct from blower assembly
and engine cylinders.
b.
Using low pressure air, blow dust and residue
from cooling ribs and blower fan.
5-11