b. Disassembly.
83. Base Plates and Rubber Mounts
a. Removal. Refer to
figure 56 and remove the
base plates and rubber mounts from the compressor
(2) Refer to figure 57 and disassemble the head.
motor.
c. Cleaning, Inspection and Repair.
b. Cleaning and Inspection.
(1) C l e a n the metal parts with an approved -
(1) Clean the metal parts with an approved
cleaning solvent and dry thoroughly.
cleaning solvent and dry thoroughly.
(2) Inspect the base plates for cracks, breaks,
(2) Inspect the compressor head for dents,
or other damage. Replace a damaged base
cracks, breaks, or other damage. Replace
plate.
a damaged compressor head.
(3) I n s p e c t the rubber mounts for cracks,
(3) Inspect the inlet valve for improper opera-
breaks, and wear. Replace damaged or
tion. Replace a defective inlet valve.
worn rubber mounts.
(4) Inspect all hardware for worn or damaged
(4) Inspect the mounting hardware for worn
threads. Replace as necessary.
or damaged threads. Replace as required.
c. Installation. Refer to figure 56 and install the
d. Reassembly.
motor.
pressor head in reverse order.
a, Removal. Refer to
figure 56 and remove the
e. Installation. Refer to figure 56 and install the
compressor head and compressor handle to the com-
pressor housing.
the compressor housing.
Figure 58. Compressor housing and motor, removal and installation.
84
TAGO 5672-A